Pace-edwards PowerGate LK902 Toggle switch Instrukcja Użytkownika Pobierz pdf

2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.com

Thank you for choosing products by...

Toggle switch

Part # LK902

PowerGate

Toggle Switch

INSTALLATION INSTRUCTIONS

LK902-07/04

STEP 1: Mount Switch

Find a location on the dashboard for your PowerGate™ toggle switch, keeping in mind that the

switch may be needed to be operated from outside the driver’s door. Make sure to check the

reverse side of the dash to insure that the area is clear of all interference and drill a 15/32” or a

.468” hole in the dash at the desired location. Remove the kurled nut and adjust the hex nut so

that the threaded housing protrudes only two threads through the dashboard. Push the switch,

handle ﬁ rst, outwards through the hole and install the kurled nut over the threaded housing and

tighten. The hex nut on the threaded housing allows you to adjust how far the toggle switch

protrudes through the dashboard.

STEP 2: Wire Switch

Using a 12-volt probe tester, locate a continuous line of power and connect the red wire from the

PowerGate™ toggle switch to that line. Find a ground wire under the dash and connect the blue

wire to this ground. Plug the two remaining female spade terminals to the white PowerGate™

lock wires.

STEP 3: Test Switch

Normal operation has the switch up to unlock and switch down to lock the PowerGate™. If

pressing the switch down unlocks the PowerGate™, change the two spade terminal connections

and test it again.

2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.comThank you for choosing products by...Toggle switchPart # LK902P

Brak uwag

Pace-edwards PowerGate LK902 Toggle switch Instrukcja Użytkownika