Pace-edwards PowerGate LK270 Chevy _ GMC Full Size (1999-2006) Instrukcja Użytkownika Pobierz pdf

2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.com

Thank you for choosing products by...

Chevy / GMC

Full Size

1999-2006

Part # LK270

STEP 1: Remove Handle Assembly

With the tailgate closed, remove the plastic bezel around the tailgate handle by pulling down and out on the top edge with

ﬁ ngers. Remove three 13 mm bolts from the handle assembly inside the tailgate. Let the handle assembly drop down enough

to rotate the plastic rod retainers so that the rods can be disconnected and removed. Remove the handle assembly.

STEP 2: Install PowerGate™

Pull on the rods enough to open the tailgate. Route the short wire harness through the drain hole at the bottom of the tailgate

and up through the latch opening such that the black plug is outside and below the tailgate. Close the tailgate. Connect the

two wires in the tailgate to the two wires located on the PowerGate motor. Put the PowerGate and the handle assembly

into the tailgate. The lock plate assembly is mounted under the handle. The lock should be assembled in the lock position.

Some minor right-or-left adjustment of the lock bar may be necessary to accommodate slight differences in tailgates. Re-

Install the three screws through the PowerGate™ and into the handle assembly and tighten.

STEP 3: Route Long Wire Harness, Relay Loom and Connect Wires

Plug the long wire harness to the short wire harness. Route the long wire harness underneath the driver’s side of the truck

to the ﬁ rewall. Using the Relay Loom on the drivers side of the engine compartment thread the purple and gray wire loom

through the ﬁ re wall of the truck. (Try to follow OEM wire routes whenever possible.)

1999 to 2002: Use the gray and tan wires located at the driver’s side end of

the dash in the fuse panel. Attach one blue wire tap to the gray and one blue

wiretap to the tan.

2003-2006: It is necessary to remove the door panel on the driver’s side and

use the Gray and Tan wires on the 2-position plug at the door lock actuator. (see

Figure 1) Attach one blue wiretap to the Gray and one to the Tan wires. Note:

there are no wires under the dash that can be used. Route the PowerGate™

wire harness through the rubber boot and into the door.

Install one blue wiretap on each of the two wires indicated above. Plug the purple and gray wires to the wire taps. Return

to the engine compartment and plug the long wire harness from the PowerGate unit to the Relay loom with the green and

blue wires. (Testing will be done later to insure appropriate connections)

Inside the engine compartment locate the positive post next to the fuse panel on the fender well. Open the cap for the

positive post, remove the nut and slip the red wire with the fuse holder on that post. Re-install the nut and close the cap.

Find the ground-wire bolt on the driver side fender well and remove it. Install the black wire to the ground-wire bolt and make

sure you get all of the black ground wires that were there when you started, re-install the bolt.

Return to the cab and make sure the door locks and tailgate lock work. Test the lock by locking and unlocking your power

door locks. If the lock/unlock direction of the PowerGate does not correspond with the direction of your door locks then

switch the purple and gray loom wires where they are attached to the door lock wires and test again.

STEP 4: Secure Wires

Re-install door panel, if removed. Install the plastic bezel around the tailgate latch. Secure all wires with wire ties provided

so that there are no loose, dangling ends.

Long Wire

Harness

Short Wire

Harness

Wire

Ties

Wire

Ta p s

PowerGate

LK270 Unit

INSTALLATION INSTRUCTIONS

LK270-12/05

Relay

Loom

Purple &

Gray wires

Green &

Blue wires

Red wire w/ fuse

holder &

black ground-wire

Truck Door

inset postition

Inside

Door

Panel

Gray & Tan Wires

Blue Clip

Fig. 1

Part # LK270 1

Podsumowanie treści

Strona 1 - Part # LK270

2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.comThank you for choosing products by...Chevy / GMC Full Size1999-

Komentarze do niniejszej Instrukcji

Brak uwag

Pace-edwards PowerGate LK270 Chevy _ GMC Full Size (1999-2006) Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Do samochodu Pace-edwards PowerGate LK270 Chevy _ GMC Full Size (1999-2006). Pace-Edwards PowerGate LK270 Chevy _ GMC Full Size (1999-2006) User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Do samochodu Pace-edwards PowerGate LK270 Chevy _ GMC Full Size (1999-2006)