STEP 5: INSTALLING RAILS
The machined end of the rail attaches to the
canister.
You will need to lift the hanging portion of the
ribbed blanket and thread it in the rail while sliding
the rail into the rail grip mounted to the ends of
the canister (the underside of the blanket ribs
need to nest on the gear).
Make sure both fl anges of rail slide into the rail
grip.
Push the rails forward against the canister.
Complete for both left and right rails.
Remove the support or stand and lower the
canister and rail assembly onto the front sill and
rails of the truck bed.
Slide the entire canister and rail assembly forward
against the cab end of the truck bed.
Close the tailgate and pull the rails
only toward it leaving approximately 1/8” gap between the end of the rails and
the tailgate.
Be sure to hold the canister in place to ensure it does not move from the front truck bed sill with the rails while
adjusting the gap of the rails to the tailgate.
Rail Grips
Rail
Flange
BEDLOCKER
®
CHVY CMS4
Ribbed
Blanket
STEP 3: INSTALL WIRING HARNESS
You will need one or two support pieces (We suggest using the top of the box the Bedlocker was shipped in) to set
in the truck bed.
Set the support piece approximately one foot from the cab.
Set the Canister on the support(s) in the truck bed. The canister should
be resting on the support piece, centered in the truck bed, raising the
top of the canister above the bed rails by 2-3 inches.
Hold onto the ribbed blanket and cut the zip tie.
(Do not let the blanket roll back on itself or the underside on the
fi rst three ribs can damage the visual surface of the other rolled
ribs).
Remove all of the vinyl sheeting protecting the blanket.
Pull the blanket out about 1 foot from the canister and let it hang.
STEP 4: PLACE CANISTER IN TRUCK BED
Support Piece
(If the optional wire harness Part# BL1120 is used, you may want to tape it to the main
harness to ease having to pull them through the stake pocket separately).
From inside the truck bed push the long wire harness end without the plug through the
stake pocket on the drivers side of the truck and out the underside of the truck bed box.
Leave approximately one foot of slack inside the box for mounting the electronics.
Route the wire harness under the truck and to the battery in the engine compartment.
Attach the fuse holder to the end of the Red/positive wire.
(Do not attach to the battery yet.)
Secure the harness with wire ties provided after slack from the canister has been taken
out.
HARDWARE USED:
WIRE HARNESS x 1
ZIP TIES x 5
(1 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji